On-board hydrogen generation from hydrocarbon fuels, such as methanol, natural gas, gasoline and diesel, etc., will be technically feasible in the near future for fuel cell powered vehicles. Among all the fuel processing methods, steam reforming is considered as the most widely used method of hydrogen reforming for the lower reactive temperature, pressure and higher hydrogen ratio in reformate. A laminate micro-channel catalytic reactor was designed for the purpose of hydrogen generation from hydrocarbons. The depth of the reaction channel is 0.5 mm, and the length and width are 50 mm and 40 mm, respectively. The same geometry is designed for the heating channels. A metal sheet is placed between reacting and heating channels to separate them. Piling up alternately the two channels is to buildup the laminate microchannel reactor. Numerical simulation has been conducted in one reactive unit, i.e., one reacting channel and one heating channel. The reactant is the solution of methanol and water mixing with a certain ratio. And the reaction heat is provided by hot air flow with a temperature of 600K. A 2D steady model of the reforming reactive processes was developed and solved numerically. The ratio of water and methanol is set to be at 1.3. The conversion rate of methanol was nearly 100% at the outlet of reactor, while the volume ratio of hydrogen is 51.4% with the selectivity of CO2 reaches 49.2%. Detail results showed that the 50 mm long reacting channel could be divided into four different regimes along with the reacting course. In the first regime (0-5mm), methanol in the reactants is almost completely converted and CO is mainly generated in the third one (15-20mm), while reactions in the other two regimes are indiscoverable. The reasons leading to such phenomena are clarified in this paper.
Numerical Simulation of Steam Reforming of Methanol in Micro-Channel Reactor
- Views Icon Views
- Share Icon Share
- Search Site
Cui, W, Li, L, Jen, T, Chen, Q, & Liao, Q. "Numerical Simulation of Steam Reforming of Methanol in Micro-Channel Reactor." Proceedings of the ASME 2005 International Mechanical Engineering Congress and Exposition. Heat Transfer, Part B. Orlando, Florida, USA. November 5–11, 2005. pp. 365-369. ASME. https://doi.org/10.1115/IMECE2005-82467
Download citation file: