Flow past a spinning circular cylinder placed in a uniform stream is investigated via three-dimensional computations. A stabilized finite element method is utilized to solve the incompressible Navier-Stokes equations in the primitive variables formulation. The Reynolds number based on the cylinder diameter and freestream speed of the flow is 200. The nondimensional rotation rate, α, (ratio of the surface speed and freestream speed) is 5. It is found that although the two-dimensional flow for is stable, centrifugal instabilities exist along the entire span in a three-dimensional set-up. In addition, a “no-slip” side-wall can result in separation of flow near the cylinder ends. Both these effects lead to a loss in lift and increase in drag. The end conditions and aspect ratio of the cylinder play an important role in the flow past a spinning cylinder. It is shown that the Prandtl’s limit on the maximum lift generated by a spinning cylinder in a uniform flow does not hold.
Three-Dimensional Instabilities in Flow Past a Rotating Cylinder
Contributed by the Applied Mechanics Division of THE AMERICAN SOCIETY OF MECHANICAL ENGINEERS for publication in the ASME JOURNAL OF APPLIED MECHANICS. Manuscript received by the Applied Mechanics Division, December 18, 2002; final revision, April 21, 2003. Associate Editor: T. E. Tezduyar. Discussion on the paper should be addressed to the Editor, Prof. Robert M. McMeeking, Chair, Department of Mechanics and Environmental Engineering, University of California–Santa Barbara, Santa Barbara, CA 93106-5070, and will be accepted until four months after final publication in the paper itself in the ASME JOURNAL OF APPLIED MECHANICS.
Mittal, S. (March 17, 2004). "Three-Dimensional Instabilities in Flow Past a Rotating Cylinder ." ASME. J. Appl. Mech. January 2004; 71(1): 89–95. https://doi.org/10.1115/1.1631032
Download citation file: