A dual gradient, deepwater drilling system based on dilution of riser mud requires economically separating the riser mud into a low density dilution fluid and a higher density drilling fluid. This study investigated the practicality of accomplishing this separation using hydrocyclones and centrifuges and examined the possible benefits and efficiency of each. The separation experiments were conducted using a laboratory centrifuge and 2 in. hydrocyclones. The laboratory centrifuge was able to separate the riser mud into near ideal densities for dilution and drilling fluid. However, the dense slurry retained in the centrifuge had lower electrical stability than the feed stream. The hydrocyclones achieved much less contrast in density between the low and high density discharges, but their use consistently resulted in a beneficial increase in the stability of the mud emulsion in all of the flow streams and gave more desirable rheological properties. A qualitative comparison indicates that the hydrocyclone separation system may offer a feasible and desirable alternative to a centrifuge separation system.
Skip Nav Destination
Article navigation
September 2011
Research Papers
Experimental Evaluation of Separation Methods for a Riser Dilution Approach to Dual Density Drilling
John Shelton,
JShelton@newpark.com
John Shelton
Newpark Drilling Fluids, LLC
, Houston, TX
Search for other works by this author on:
John Rogers Smith,
Jsmith5@lsu.edu
John Rogers Smith
Louisiana State University
, Baton Rouge, LA
Search for other works by this author on:
Anuj Gupta
anuj.gupta@qatar.tamu.edu
Anuj Gupta
Texas A & M University at Qatar
, Doha, Qatar
Search for other works by this author on:
John Shelton
John Rogers Smith
Anuj Gupta
J. Energy Resour. Technol. Sep 2011, 133(3): 031501 (5 pages)
Published Online: October 3, 2011
Article history
Received:
March 23, 2010
Revised:
August 24, 2011
Published:
October 3, 2011
Connected Content
Citation
Shelton, J., Smith, J. R., and Gupta, A. (October 3, 2011). "Experimental Evaluation of Separation Methods for a Riser Dilution Approach to Dual Density Drilling." ASME. J. Energy Resour. Technol. September 2011; 133(3): 031501. https://doi.org/10.1115/1.4004968
Download citation file:
Get Email Alerts
Cited By
Numerical Study of Composite Percussive Drilling With Consideration of Heat Transfer Between Drilling Fluid and Bottom-Hole Rock in Geothermal Drilling
J. Energy Resour. Technol (June 2023)
An Investigation of the Impact of Combustion Chamber Geometry on Turbulent Burning Speeds in a Thermodynamic Model
J. Energy Resour. Technol (June 2023)
Synergy in Syngas Yield From Co-Pyrolysis of Cow and Chicken Manures
J. Energy Resour. Technol (June 2023)
Related Articles
Publisher’s Note: “Experimental Evaluation of Separation Methods for a Riser Dilution Approach to Dual Density Drilling” [Journal Energy Resources Technology, 2011, 133, 031501]
J. Energy Resour. Technol (December,2011)
A Modular Differential Dielectric Sensor for Use in Multiphase Separation, Process Measurement, and Control—Part II: Experimental Investigation
J. Energy Resour. Technol (December,2011)
Sagging Prevention for Hematite-Based Invert Emulsion Mud
J. Energy Resour. Technol (July,2022)
A Theoretical Description of a Dilute Emulsion of Very Viscous Drops Undergoing Unsteady Simple Shear
J. Fluids Eng (October,2011)
Related Proceedings Papers
Related Chapters
Contamination and Impacts of Exploration and Production Waste Constituents
Guidebook for Waste and Soil Remediation: For Nonhazardous Petroleum and Salt Contaminated Sites
Research on the Effect of XC and Clay on the Rheological Behavior of Gas Hydrate Drilling Fluids
Geological Engineering: Proceedings of the 1 st International Conference (ICGE 2007)
Chitosan-Based Drug Delivery Systems
Chitosan and Its Derivatives as Promising Drug Delivery Carriers