By considering time-dependent terms as external excitation forces, the approximate dynamic response of a cracked horizontal rotor is analyzed theoretically and numerically. The solution is good for small cracks and small vibrations in the stable operating range. For each steady-state harmonic component, the forward and backward whirl amplitudes, the shape and orientation of the elliptic orbit, and the amplitude and phase of the response signals are analyzed, taking into account the effect of crack size, crack location, rotor speed, and unbalance. It is found that the crack causes backward whirl, the amplitude of which increases with the crack. For a cracked rotor, the response orbit for each harmonic component is an ellipse, the shape and orientation of which depend on the crack size. The influence of the crack on the synchronous response of the system can be regarded as an additional unbalance whereupon, depending on the speed and the crack location, the response amplitude differs from that of the uncracked rotor. The nonsynchronous response provides evidence of crack in the subcritical range, but is too small to be detected in the supercritical range. Possibilities for crack detection over the full-speed range include the additional average (the constant) response component, the backward whirl of the response, the ellipticity of the orbit, the angle between the major axis and the vertical axis, and the phase angle difference between vertical and horizontal vibration signals.

1.
Bently Nevada, 1986, “Early Shaft Crack Detection on Rotating Machinery Using Vibration Monitoring and Diagnostics,” Technical Bulletin No. L1036-00, No. 1.
2.
Dimarogonas
A. D.
, and
Papadopoulos
C. A.
,
1983
, “
Vibration of Cracked Shaft in Bending
,”
J. Sound and Vibration
, Vol.
91
, pp.
583
593
.
3.
Fridemann
P.
, et al.,
1977
, “
Efficient Numerical Treatment of Periodic Systems With Application to Stability Problems
,”
Intl. J. for Numerical Methods in Engineering
, Vol.
11
, pp.
1117
1136
.
4.
Gasch, R., 1993, “A Survey of the Dynamic Behaviour of a Simple Rotating Shaft With a Transverse Crack,” J. Sound and Vibration, vol. 157, No. 1.
5.
Grabowski
B.
,
1980
, “
The Vibrational Behaviour of a Turbine Rotor Containing a Transverse Crack
,”
ASME Journal of Mechanical Design
, Vol.
102
, pp.
140
146
.
6.
Haas
H.
,
1977
, “
Major Damage Caused by Turbine or Generator Rotors in the Range up to Tripping Speed
,”
Der Maschinenschaden
, Vol.
50
, pp.
193
215
.
7.
Iman
I.
, et al.,
1989
, “
Development of an On-Line Rotor Crack Detection and Monitoring System
,”
ASME Journal of Vibration, Acoustics, Stress, and Reliability in Design
, Vol.
111
, pp.
241
250
.
8.
Jack, A. R., and Patterson, A. N., 1977, “Cracking in 500MW LP Rotor Shaft,” I Mech E Conference on The Influence of the Environment on Fatigue.
9.
Meng, G., and Gasch, R., 1992, “The Nonlinear Influence of Whirl Speed on the Stability and Response of a Cracked Rotor,” J. of Machine Vibration, No. 4, pp. 216–230.
10.
Muszynska, A., et al., 1992, “Torsional/Lateral Vibration Cross-Coupled Responses Due to Shaft Anisotropy: A New Tool in Shaft Crack Detection,” C432/090, Proc. of I Mech E, Vibrations in Rotating Machinery, pp. 257–262.
11.
Nelson
H. D.
, and
Nataraj
C.
,
1986
, “
The Dynamics of a Rotor System With a Cracked Shaft
,”
ASME Journal of Vibration, Acoustics, Stress, and Reliability in Design
, Vol.
108
, pp.
189
196
.
12.
Wauer
J.
,
1990
, “
On the Dynamics of Cracked Rotors: A Literature Survey
,”
Appl. Mech. Review
, Vol.
43
, No.
1
, pp.
13
17
.
This content is only available via PDF.
You do not currently have access to this content.