1-20 of 52
Keywords: steam turbines
Close
Sort by
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Eng. Gas Turbines Power. April 2019, 141(4): 041003.
Paper No: GTP-18-1560
Published Online: November 1, 2018
.... In Part II, five cases of geometry with different axial distances between the swirl breaker and the rotor shroud, which covered a range for the stage axial distance of actual high and intermediate pressure (HIP) steam turbines, were investigated using a single-rotor computational fluid dynamics (CFD...
Journal Articles
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. March 2012, 134(3): 031801.
Published Online: December 30, 2011
..., the advantages, and the information obtained from an advanced exergoeconomic analysis by applying it to a complex plant, i.e., to a combined cycle power plant. The largest parts of the unavoidable cost rates are calculated for the components constituting the gas turbine system and the low-pressure steam turbine...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. January 2012, 134(1): 013001.
Published Online: November 4, 2011
...James Spelling; Markus Jöcker; Andrew Martin Steam turbines in solar thermal power plants experience a much greater number of starts than those operating in baseload plants. In order to preserve the lifetime of the turbine while still allowing fast starts, it is of great interest to find ways...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. November 2011, 133(11): 113002.
Published Online: May 18, 2011
...Mario Álvarez Fernández; Cristina Alonso-Tristán A model is described that studies the behavior of a steam turbine on the basis of the law of conservation of energy even under wet-steam conditions at particular points in time. Initially, the hypothesis that steam expansion follows a polytropic...
Journal Articles
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. June 2011, 133(6): 063001.
Published Online: February 14, 2011
... conditions using high ash (HA) indigenous coal. A unit size of 800 MWe presently under development in India is considered for energy and exergy analysis of power plants. Commercially established steam turbine parameters are used for the optimization of SupC power plant, whereas advanced steam turbine...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. March 2011, 133(3): 032502.
Published Online: November 11, 2010
... friction numerical analysis steam turbines vibration control Experimental investigation of the dynamic response of structures such as bladed disks in gas and steam turbines is still of great importance. The exciting force pattern on the bladed disks is due to the gas (or steam) flowing through...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. February 2011, 133(2): 022501.
Published Online: October 26, 2010
... Santos et al. ( 7 8 ) addressed blade-shaft coupled bending vibrations as control issues by examining the control of blade vibrations through shaft vibration control using wind turbines or steam turbines. Such control tries to reduce shaft and blade vibrations by flexible bearing support...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. January 2011, 133(1): 012501.
Published Online: September 27, 2010
... on the inboard bearing No. 3 of the fast gear shaft, illustrated in Fig. 18 , showed to be not affected by any significant peak. Therefore, the excitation of flexural normal modes of the steam turbine did not affect the lateral vibrations of the slow gear shaft. Bode plot of the 1 X transient...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. November 2010, 132(11): 112501.
Published Online: August 5, 2010
...Andrea Tonoli; Nicola Amati; Angelo Bonfitto; Mario Silvagni; Bernard Staples; Evgueni Karpenko The vibration control of rotors for gas or steam turbines is usually performed using passive dampers when hydrodynamic bearings are not used. In layouts where the rotating parts are supported by rolling...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. October 2010, 132(10): 102905.
Published Online: July 2, 2010
...Jun Manabe; Jiro Kasahara; Issaku Fujita; Toshiki Kojima The moisture separator reheater (MSR) is a key piece of equipment in reheat systems in nuclear steam turbines that use saturated main steam, where it helps improve turbine efficiency and suppress flow-accelerated corrosion. Fundamental...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. August 2010, 132(8): 082501.
Published Online: May 26, 2010
... analysis Galerkin method iterative methods mechanical contact reduced order systems steam turbines thermal stresses time-domain analysis vibrations The rotor blades of a low pressure (LP) steam turbine stage are subjected to high static and dynamic loads during operation. The static loads...
Journal Articles
Publisher: ASME
Article Type: Technical Briefs
J. Eng. Gas Turbines Power. June 2010, 132(6): 064501.
Published Online: March 16, 2010
...Daren Yu; Yanfeng Duan; Jinfu Liu; Zhansheng Liu; Qinghua Hu It is noticed in a few steam turbines that there are a pad temperature rise of more than 10 ° C and a radial journal movement of more than 50 μ m in the bearings adjacent to control stage when they operate under partial arc admission...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. May 2010, 132(5): 052505.
Published Online: March 5, 2010
...Jacob Laborenz; Christian Siewert; Lars Panning; Jörg Wallaschek; Christoph Gerber; Pierre-Alain Masserey In gas and steam turbine applications a common approach to prevent the blades from high cycle fatigue failures due to high vibration amplitudes is the usage of friction damping elements...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. May 2010, 132(5): 052101.
Published Online: March 4, 2010
... 04 03 2010 04 03 2010 aluminium compounds chromium compounds corrosion protective coatings corrosion resistance gas turbines iron compounds mechanical engineering computing nanostructured materials nickel compounds phase diagrams steam turbines Energy-producing steam...
Journal Articles
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. September 2009, 131(5): 053001.
Published Online: May 28, 2009
...Shimin Deng; Rory Hynes In this paper, pressurized oxy-fuel combustion power generation processes are modeled and analyzed based on a 350 MW subcritical reheat boiler associated with a condensing steam turbine. The performance results are obtained. Furthermore, the influences of slurry...
Journal Articles
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. March 2009, 131(2): 021601.
Published Online: December 18, 2008
... are demonstrated by its application to a single-shaft combined cycle with both gas turbine and steam turbine driving a common generator. In the absence of a reliable and accurate measuring system to individually determine gas and steam turbine shaft outputs, data reconciliation is vital to an accurate analysis...