We consider the flow of humid air over fin-tube multi-row multi-column compact heat exchangers with possible condensation. Previously published experimental data are used to show that a regression analysis for the best-fit correlation of a prescribed form does not provide an unique answer, and that there are small but significant differences between the predictions of the different correlations thus obtained. It is also shown that it is more accurate to predict the heat rate directly rather than through intermediate quantities like the j-factors. The artificial neural network technique is offered as an alternative technique. It is trained with experimental values of the humid-air flow rates, dry-bulb and wet-bulb inlet temperatures, fin spacing, and heat transfer rates. The trained network is then used to make predictions of the heat transfer. Comparison of the results demonstrates that the neural network is more accurate than conventional correlations.
Issue Section:
Heat Exchangers
1.
Jacobi
, A. M.
, and Goldschmidt
, V. W.
, 1990
, “Low Reynolds Number Heat and Mass Transfer Measurements of an Overall Counterflow, Baffled, Finned-Tube, Condensing Heat Exchanger
,” Int. J. Heat Mass Transf.
, 33
, No. 4
, pp. 755
–765
.2.
Srinivasan
, V.
, and Shah
, R. K.
, 1997
, “Condensation in Compact Heat Exchangers
,” Journal of Enhanced Heat Transfer
, 4
, No. 4
, pp. 237
–256
.3.
Ramadhyani, S., 1998, “Calculation of Air-Side Heat Transfer in Compact Heat Exchangers Under Condensing Conditions,” in Computer Simulations in Compact Heat Exchangers, 1, Computational Mechanics Publications, B. Sunden and M. Faghri editors, South Hampton, UK., pp. 151–168.
4.
Jang
, J. Y.
, Lai
, J. T.
, and Liu
, L. C.
, 1998
, “The Thermal-Hydraulic Characteristics of Staggered Circular Finned-Tube Heat Exchangers Under Dry and Dehumidifying Conditions
,” Int. J. Heat Mass Transf.
, 41
, pp. 3321
–3337
.5.
Sen, M., and Yang, K. T., 1999, “Applications of Artificial Neural Networks and Genetic Algorithms in Thermal Engineering,” CRC Handbook of Thermal Engineering, F. Kreith, ed., Section 4.24 pp. 620–661.
6.
Thibault
, J.
, and Grandjean
, B. P. A.
, 1991
, “A Neural Network Methodology for Heat Transfer Data Analysis
,” Int. J. Heat Mass Transf.
, 34
, No. 8
, pp. 2063
–2070
.7.
Mahajan
, R. L.
, and Wang
, X. A.
, 1993
, “Neural Network Models for Thermally Based Microelectronic Manufacturing Processes
,” J. Electrochem. Soc.
, 140
, No. 8
, pp. 2287
–2293
.8.
Marwah
, M.
, Li
, Y.
, and Mahajan
, R. L.
, 1996
, “Integrated Neural Network Modeling for Electronic Manufacturing
,” J. Electron. Manufact.
, 6
, No. 2
, pp. 79
–91
.9.
Fowler, M. M., Klett, D. E., Moreno, J. B., and Heermann, P. D., 1997, “Using Artificial Neural Networks to Predict the Performance of a Liquid Sodium Reflux Pool Boiler Solar Receiver,” in Proceedings of the International Solar Energy Conference, pp. 93–104.
10.
Jambunathan
, K.
, Hartle
, S. L.
, Ashforth-Frost
, S.
, and Fontama
, V. N.
, 1996
, “Evaluating Convective Heat Transfer Coefficients Using Neural Networks
,” Int. J. Heat Mass Transf.
, 39
, No. 11
, pp. 2329
–2332
.11.
Jeannette
, E.
, Assawamartbunlue
, K.
, Curtiss
, P. S.
, and Kreider
, J. F.
, 1998
, “Experimental Results of a Predictive Neural Network HVAC Controller,” in
ASHRAE Trans.
, 104, Part 2
, pp. 192
–197
.12.
Zhao, X., McClain, R. L., Sen, M., and Yang, K. T., 1995, “An Artificial Neural Network Model of a Heat Exchanger,” in Symposium on Thermal Science and Engineering in Honor of Chancellor Chang-Lin Tien, pp. 83–88.
13.
Dı´az
, G.
, Sen
, M.
, Yang
, K. T.
, and McClain
, R. L.
, 1999
, “Simulation of Heat Exchanger Performance by Artificial Neural Networks
,” Int. J. HVAC Res.
, 5
, No. 3
, pp. 195
–208
.14.
McQuiston
, F. C.
, 1976
, “Heat, Mass and Momentum Transfer in a Parallel Plate dehumidifying Exchanger,” in
ASHRAE Trans.
, 82, Part 2
, pp. 87
–106
.15.
McQuiston
, F. C.
, 1978
, “Heat, Mass and Momentum Transfer Data for Five Plate-Fin-Tube Heat Transfer Surfaces
,” ASHRAE Trans.
, 84
, Part 1, pp. 266
–293
.16.
McQuiston
, F. C.
, 1978
, “Correlation of Heat, Mass and Momentum Transport Coefficients for Plate-Fin-Tube Heat Transfer Surfaces With Staggered Tubes
,” ASHRAE Trans.
, 84, Part 1
, pp. 294
–309
.17.
Gray, D. L., and Webb, R. L., 1986, “Heat Transfer and Friction Correlations for Plate Finned-Tube Heat Exchangers Having Plain Fins,” in Proceedings of the Eighth International Heat Transfer Conference, 6, pp. 2745–2750.
18.
Pacheco-Vega, A., Sen M., Yang, K. T., and McClain, R. L., 1998, “Genetic-Algorithm-Based Predictions of Fin-Tube Heat Exchanger Performance,” in Proceedings of the Eleventh International Heat Transfer Conference, 6, pp. 137–142.
19.
Zeng
, P.
, 1998
, “Neural Computing in Mechanics
,” Appl. Mech. Rev.
, 51
, No. 2
, pp. 173
–197
.20.
Rumelhart, D. E., Hinton, G. E., and Williams, R. J., 1986, “Learning Internal Representations by Error Propagation,” in Parallel Distributed Processing: Explorations in the Microstructure of Cognition, MIT Press, Cambridge, MA.
21.
Theodoridis, S., and Koutroumbas, K., 1999, Pattern Recognition, Academic Press, San Diego, CA.
Copyright © 2001
by ASME
You do not currently have access to this content.
