The detailed distributions of heat transfer coefficient and film cooling effectiveness on a gas turbine blade tip were measured using a hue detection based transient liquid crystals technique. Tests were performed on a five-bladed linear cascade with blow-down facility. The Reynolds number based on cascade exit velocity and axial chord length was and the total turning angle of the blade was 97.7°. The overall pressure ratio was 1.2 and the inlet and exit Mach numbers were 0.25 and 0.59, respectively. The turbulence intensity level at the cascade inlet was 9.7%. The blade model was equipped with a single row of film cooling holes at both the tip portion along the camber line and near the tip region of the pressure side. All measurements were made at the three different tip gap clearances of 1.0%, 1.5%, and 2.5% of blade span and the three blowing ratios of 0.5, 1, and 2. Results showed that, in general, heat transfer coefficient and film effectiveness increased with increasing tip gap clearance. As blowing ratio increased, heat transfer coefficient decreased, while film effectiveness increased. Results also showed that adding pressure side coolant injection would further decrease the blade tip heat transfer coefficient but increase film-cooling effectiveness.
Heat Transfer Coefficients and Film-Cooling Effectiveness on a Gas Turbine Blade Tip
Contributed by the Heat Transfer Division for publication in the JOURNAL OF HEAT TRANSFER. Manuscript received by the Heat Transfer Division May 17, 2002; revision received December 27, 2002. Associate Editor: K. S. Ball.
- Views Icon Views
- Share Icon Share
- Search Site
Kwak, J. S., and Han, J. (May 20, 2003). "Heat Transfer Coefficients and Film-Cooling Effectiveness on a Gas Turbine Blade Tip ." ASME. J. Heat Transfer. June 2003; 125(3): 494–502. https://doi.org/10.1115/1.1565096
Download citation file: