The two-phase flow and boiling heat transfer in horizontal metal-foam filled tubes are experimentally investigated. The results show that the heat transfer is almost doubled by reducing the cell size from 20 ppi to 40 ppi for a given porosity, thanks to more surface area and strong flow mixing for the smaller cell size. The boiling heat transfer coefficient keeps steady rising, albeit slowly, by increasing the vapor quality for high mass flow rates, while the same story does not hold for the cases of low mass flow rates. The flow pattern can be indirectly judged through monitoring the cross-sectional wall surface temperature fluctuations and wall-refrigerant temperature difference. As the operating pressure increases, the boiling heat transfer at low vapor quality exhibits similar behavior with pool boiling heat transfer, namely, the heat transfer is enhanced by improving the pressure. However the flow boiling heat transfer is suppressed to some extent as the pressure increases. The heat transfer coefficient of copper foam tubes is approximately three times higher than that of plain tubes.
Skip Nav Destination
Article navigation
December 2009
This article was originally published in
Journal of Heat Transfer
Research Papers
Flow Boiling Heat Transfer in Horizontal Metal-Foam Tubes
W. Lu,
W. Lu
School of Engineering,
University of Warwick
, Coventry CV4 7AL, UK
Search for other works by this author on:
S. A. Tassou
S. A. Tassou
School of Engineering and Design,
Brunel University
, Uxbridge, Middlesex UB8 3PH, UK
Search for other works by this author on:
C. Y. Zhao
W. Lu
School of Engineering,
University of Warwick
, Coventry CV4 7AL, UK
S. A. Tassou
School of Engineering and Design,
Brunel University
, Uxbridge, Middlesex UB8 3PH, UKJ. Heat Transfer. Dec 2009, 131(12): 121002 (8 pages)
Published Online: October 15, 2009
Article history
Received:
August 16, 2007
Revised:
October 20, 2008
Published:
October 15, 2009
Citation
Zhao, C. Y., Lu, W., and Tassou, S. A. (October 15, 2009). "Flow Boiling Heat Transfer in Horizontal Metal-Foam Tubes." ASME. J. Heat Transfer. December 2009; 131(12): 121002. https://doi.org/10.1115/1.3216036
Download citation file:
Get Email Alerts
Cited By
On Prof. Roop Mahajan's 80th Birthday
J. Heat Mass Transfer
Thermal Hydraulic Performance and Characteristics of a Microchannel Heat Exchanger: Experimental and Numerical Investigations
J. Heat Mass Transfer (February 2025)
Related Articles
Direct Simulation of Transport in Open-Cell Metal Foam
J. Heat Transfer (August,2006)
Simulation of Thermal Transport in Open-Cell Metal Foams: Effect of Periodic Unit-Cell Structure
J. Heat Transfer (February,2008)
Flow Boiling Heat Transfer Characteristics of a Minichannel up to Dryout Condition
J. Heat Transfer (August,2011)
Pool Boiling Heat Transfer From Plain and Microporous, Square Pin-Finned Surfaces in Saturated FC-72
J. Heat Transfer (August,2000)
Related Chapters
Heat Transfer Enhancement for Thermal Energy Storage Using Metal Foams Embedded within Phase Change Materials (PCMS)
Inaugural US-EU-China Thermophysics Conference-Renewable Energy 2009 (UECTC 2009 Proceedings)
Thermal Design Guide of Liquid Cooled Systems
Thermal Design of Liquid Cooled Microelectronic Equipment
Liquid Cooled Systems
Thermal Management of Telecommunication Equipment, Second Edition