While microchannel flow boiling has received much research attention, past work has not considered the impact of acoustic waves generated by rapidly nucleating bubbles. The present work provides a theoretical framework for these pressure waves, which resembles classical “water hammer” theory and predicts a strong influence on bubble nucleation rates and effective convection coefficients. These pressure waves result directly from confinement in microchannel geometries, reflect from geometrical transitions, and superimpose to create large transients in the static liquid pressure. Feedback from the pressure waves inhibits bubble growth rates, reducing the effective heat transfer. Pressure depressions generated by the propagating pressure pulses can cause other bubbles to grow at lower than expected wall temperatures. The additional nucleation enhances heat transfer over short times but increased flow instability may inhibit heat transfer over longer periods. The limited quantitative measurements available in the literature indicate confined bubble growth rates in microchannels are significantly lower than those predicted by the classical Rayleigh–Plesset equation. The present model predicts confined bubble growth rates to within ± 20%. A nondimensional number indicative of the relative magnitude of the water hammer pressure to bubble pressure is proposed to characterize the transitions from conventional to microchannel flow boiling.
Skip Nav Destination
Article navigation
December 2009
This article was originally published in
Journal of Heat Transfer
Research Papers
Bubble-Induced Water Hammer and Cavitation in Microchannel Flow Boiling
Kenneth E. Goodson
Kenneth E. Goodson
Department of Mechanical Engineering,
Stanford University
, Building 530, Room 224, Stanford, CA 94305
Search for other works by this author on:
David W. Fogg
Kenneth E. Goodson
Department of Mechanical Engineering,
Stanford University
, Building 530, Room 224, Stanford, CA 94305J. Heat Transfer. Dec 2009, 131(12): 121006 (12 pages)
Published Online: October 15, 2009
Article history
Received:
February 13, 2008
Revised:
October 7, 2008
Published:
October 15, 2009
Citation
Fogg, D. W., and Goodson, K. E. (October 15, 2009). "Bubble-Induced Water Hammer and Cavitation in Microchannel Flow Boiling." ASME. J. Heat Transfer. December 2009; 131(12): 121006. https://doi.org/10.1115/1.3216381
Download citation file:
Get Email Alerts
Cited By
Entropic Analysis of the Maximum Output Power of Thermoradiative Cells
J. Heat Mass Transfer
Molecular Dynamics Simulations in Nanoscale Heat Transfer: A Mini Review
J. Heat Mass Transfer
Related Articles
Effects of Dissolved Air on Subcooled Flow Boiling of a Dielectric Coolant in a Microchannel Heat Sink
J. Electron. Packag (December,2006)
Phase-Change Heat Transfer in Microsystems
J. Heat Transfer (February,2007)
Flow Boiling Instabilities in Microchannels and Means for Mitigation by Reentrant Cavities
J. Heat Transfer (July,2008)
Physics of the Microchannel Flow Boiling Process and Comparison With the Existing Theories
J. Heat Transfer (November,2017)
Related Proceedings Papers
Related Chapters
Experiment Investigation of Flow Boiling Process Including Cavitation in Micro-Channel
Inaugural US-EU-China Thermophysics Conference-Renewable Energy 2009 (UECTC 2009 Proceedings)
Thermal Design Guide of Liquid Cooled Systems
Thermal Design of Liquid Cooled Microelectronic Equipment
A Reduced Order Gas Pressure Law for Single Acoustic Cavitation Bubbles
Proceedings of the 10th International Symposium on Cavitation (CAV2018)