In an effort to provide insights into the thermochemical composition of a microwave plasma chemical vapor deposition (MPCVD) reactor, the mole fraction of H2 is measured at various positions in the plasma sheath, at pressures of 10 and 30 Torr, and at plasma powers ranging from 300 to 700 W. A technique is developed by comparing the Q(1)01 transition of experimental and theoretical spectra aided by the Sandia CARSFT fitting routine. Results reveal that the mole fraction of H2 does not vary significantly from its theoretical mixture at the parametric conditions examined. Furthermore, the vibrational hot band was searched, but no transitions were found. An analytical explanation for the increase in the temperature of H2 with the introduction of N2 and CH4 is also presented. Finally, because the mole fraction of H2 does not appear to deviate from the theoretical composition, the rotational and translational modes of H2 are shown to be approximately in equilibrium, and therefore, the rotational temperatures may be used to estimate the translational temperatures of H2.
Skip Nav Destination
Article navigation
March 2016
This article was originally published in
Journal of Micro and Nano-Manufacturing
Research-Article
H2 Mole Fraction Measurements in a Microwave Plasma Using Coherent Anti-Stokes Raman Scattering Spectroscopy
Alfredo D. Tuesta,
Alfredo D. Tuesta
Nanoscale Transport Research Group,
School of Mechanical Engineering,
Purdue University,
West Lafayette, IN 47907
e-mail: alfredotuesta@gmail.com
School of Mechanical Engineering,
Purdue University,
West Lafayette, IN 47907
e-mail: alfredotuesta@gmail.com
Search for other works by this author on:
Aizaz Bhuiyan,
Aizaz Bhuiyan
Applied Laser Spectroscopy Laboratory,
School of Mechanical Engineering,
Purdue University,
West Lafayette, IN 47907
e-mail: abhuiyan@purdue.edu
School of Mechanical Engineering,
Purdue University,
West Lafayette, IN 47907
e-mail: abhuiyan@purdue.edu
Search for other works by this author on:
Robert P. Lucht,
Robert P. Lucht
Applied Laser Spectroscopy Laboratory,
School of Mechanical Engineering,
Purdue University,
West Lafayette, IN 47907
e-mail: lucht@purdue.edu
School of Mechanical Engineering,
Purdue University,
West Lafayette, IN 47907
e-mail: lucht@purdue.edu
Search for other works by this author on:
Timothy S. Fisher
Timothy S. Fisher
Nanoscale Transport Research Group,
School of Mechanical Engineering,
Purdue University,
West Lafayette, IN 47907
e-mail: tsfisher@purdue.edu
School of Mechanical Engineering,
Purdue University,
West Lafayette, IN 47907
e-mail: tsfisher@purdue.edu
Search for other works by this author on:
Alfredo D. Tuesta
Nanoscale Transport Research Group,
School of Mechanical Engineering,
Purdue University,
West Lafayette, IN 47907
e-mail: alfredotuesta@gmail.com
School of Mechanical Engineering,
Purdue University,
West Lafayette, IN 47907
e-mail: alfredotuesta@gmail.com
Aizaz Bhuiyan
Applied Laser Spectroscopy Laboratory,
School of Mechanical Engineering,
Purdue University,
West Lafayette, IN 47907
e-mail: abhuiyan@purdue.edu
School of Mechanical Engineering,
Purdue University,
West Lafayette, IN 47907
e-mail: abhuiyan@purdue.edu
Robert P. Lucht
Applied Laser Spectroscopy Laboratory,
School of Mechanical Engineering,
Purdue University,
West Lafayette, IN 47907
e-mail: lucht@purdue.edu
School of Mechanical Engineering,
Purdue University,
West Lafayette, IN 47907
e-mail: lucht@purdue.edu
Timothy S. Fisher
Nanoscale Transport Research Group,
School of Mechanical Engineering,
Purdue University,
West Lafayette, IN 47907
e-mail: tsfisher@purdue.edu
School of Mechanical Engineering,
Purdue University,
West Lafayette, IN 47907
e-mail: tsfisher@purdue.edu
1Corresponding author.
Contributed by the Manufacturing Engineering Division of ASME for publication in the JOURNAL OF MICRO- AND NANO-MANUFACTURING. Manuscript received July 21, 2015; final manuscript received October 24, 2015; published online December 15, 2015. Assoc. Editor: Don A. Lucca.
J. Micro Nano-Manuf. Mar 2016, 4(1): 011005 (9 pages)
Published Online: December 15, 2015
Article history
Received:
July 21, 2015
Revised:
October 24, 2015
Citation
Tuesta, A. D., Bhuiyan, A., Lucht, R. P., and Fisher, T. S. (December 15, 2015). "H2 Mole Fraction Measurements in a Microwave Plasma Using Coherent Anti-Stokes Raman Scattering Spectroscopy." ASME. J. Micro Nano-Manuf. March 2016; 4(1): 011005. https://doi.org/10.1115/1.4031916
Download citation file:
109
Views
Get Email Alerts
Cited By
Reviewer's Recognition
J. Micro Nano Sci. Eng (June 2025)
Reviewer's Recognition
J. Micro Nano Sci. Eng (June 2025)
Fabrication and Characterization of Metallic Glass Nanowire-Anchored Microfluidic Channels
J. Micro Nano Sci. Eng (June 2025)
Design of Experiments Informed Investigation of Magnetic Field-Assisted Nickel Electroplating on Copper
J. Micro Nano Sci. Eng (June 2025)
Related Articles
Laser Diagnostics of Plasma in Synthesis of Graphene-Based Materials
J. Micro Nano-Manuf (September,2014)
Experimental Setup of a Laser Diagnostics System for a High-Temperature Solar Receiver/Reactor
J. Sol. Energy Eng (November,1994)
Flame Stability in Inverse Coaxial Injector Using Repetitive Nanosecond Pulsed Plasma
J. Energy Resour. Technol (August,2020)
Related Chapters
Cooling a Radar’s Electronic Board
Electromagnetic Waves and Heat Transfer: Sensitivites to Governing Variables in Everyday Life
Compressive Deformation of Hot-Applied Rubberized Asphalt Waterproofing
Roofing Research and Standards Development: 10th Volume
Front Matter
Methodology Used to Update the Gasoline Volatility Schedule for U.S. Seasonal and Geographic Classes