This paper reports on the numerical assessment of the differences in aerodynamic performance between part span shrouded and unshrouded fan blades generally found in the first stage of multistage fans in low bypass ratio aircraft engines. Rotor flow fields for both blade designs were investigated at two operating conditions using a three-dimensional viscous flow analysis. Although designed to the same radius ratio, aspect ratio, and solidity, the unshrouded fan rotor had a slightly increased tip speed $(+3%)$ and somewhat lower pressure ratio $(−3.2%)$ due to engine cycle requirements. Even when allowing for these small differences, the analysis reveals interesting differences in the level and in the radial distribution of efficiency between these two rotors. The reason for the improved performance of the shrouded rotor in part can be attributed to the shroud blocking off the radial migration of boundary layer fluid centrifuged from the hub on the suction side. As a result, the shock boundary layer interaction seems to be improved on the shrouded blade. At the cruise condition, the efficiency is the same for both rotors. The slightly better efficiency of the shrouded blade in the outer panel is nullified by the large efficiency penalty in the vicinity of the shroud. As there is no significant radial migration of fluid in the suction side boundary layer, as indicated by the analysis at this condition relative to the design speed case, the benefit due to the shroud is greatly reduced. At this speed and at lower speeds, the shroud becomes a net additional loss for the blade. Also of interest from the numerical results is the indication that significant blade ruggedization penalties to performance can be reduced in the case of the unshrouded blade through custom tailoring of its mean camber line.

1.
,
A. R.
, and
James
,
F.
, 2001, “
F110-GE-129 EFE—Enhanced Power Through Low Risk Derivative Technology
,”
ASME J. Turbomach.
0889-504X,
123
, pp.
544
551
.
2.
Esgar
,
G. M.
, and
Sandercock
,
D. M.
, 1973, “
Some Observed Effects of Part Span Dampers on Rotating Blade Row Performance Near Design Point
,” NASA Paper No. TM X-2696.
3.
Benser
,
W. A.
,
Bailey
,
E. E.
, and
Gelder
,
T. F.
, 1975, “
Holographic Studies of Shock Waves Within Transonic Fan Rotors
,”
ASME J. Eng. Power
0022-0825,
97
, pp.
75
84
.
4.
Reid
,
L.
, and
Tysl
,
E. R.
, 1974, “
Performance of a Transonic Rotor With an Aspect Ratio of 6.5
,” NASA Paper No. TN D-7662.
5.
Lewis
,
G. W.
, and
Urasek
,
D. C.
, 1972, “
Comparison of the Effect of Two Damper Sizes on the Performance of a Low Solidity Axial Flow Transonic Compressor Rotor
,” NASA Paper No. TMX-2536.
6.
Messenger
,
H. E.
, and
Keenan
,
M. J.
, 1974, “
Two Stage Fan 2: Data and Performance With Redesigned Second Stage Rotor Uniform and Distorted Inlet Flows
,” NASA Paper No. CR-134710.
7.
Ware
,
T. C.
,
Kobayashi
,
R. J.
, and
Jackson
,
R. J.
, 1974, “
High Tip Speed Low Loading Transonic Fan Stage. Part 3: Final Report
,” NASA Paper No. CR-121263.
8.
Koch
,
C. C.
, and
Smith
,
L. H.
, Jr.
, 1975, “
Loss Sources and Magnitudes in Axial-Flow Compressors
,” ASME Paper No. 75-WA∕GT-6.
9.
Roberts
,
W. B.
, 1978, “
A Design Point Correlation for Losses Due to Part Span Dampers on Transonic Rotors
,” ASME Paper No. 78-GT-153.
10.
Cumpsty
,
N. A.
, and
Greitzer
,
E. M.
, 2004, “
Ideas and Methods of Turbomachinery Aerodynamics: A Historical View
,”
J. Propul. Power
0748-4658,
20
(
1
), pp.
15
26
.
11.
,
G. G.
, and
Smith
,
L. H.
, 1982, “
Spanwise Mixing in Axial Flow Turbomachines
,”
ASME J. Eng. Power
0022-0825,
104
, pp.
97
110
.
12.
,
A. R.
, and
Copenhaver
,
W. W.
, 1996, “
An Investigation of the Effect of Cascade Area Ratios on Transonic Compressor Performance
,”
ASME J. Turbomach.
0889-504X,
118
, pp.
760
770
.
13.
Jennions
,
I. K.
, and
Turner
,
M. G.
, 1993, “
Three-Dimensional Navier–Stokes Computations of Transonic Flow Using an Explicit Flow Solver and an Implicit K-E Solver
,”
ASME J. Turbomach.
0889-504X,
115
, pp.
261
272
.
14.
Roberts
,
W. B.
,
Crouse
,
J. E.
, and
Sandercock
,
D. M.
, 1979, “
An Off-Design Correlation of Part Span Damper Losses Through Transonic Axial Fan Rotors
,” ASME Paper No. 79-GT-6.